Coche con mango phi de 22,2 mm exclusivo para 12 V
Longitud total de la empuñadura : 120mm tipo de extremo final (Bar-end puede ser instalado)
Diámetro interior de la empuñadura (derecha) : 24.4mm phi (izquierda) : Φ21.2mm
La sobredosis de la pinza. : Φ33.6mm
*Los niveles 3 y 4 no son adecuados para su uso con los niveles 3 y 4, ya que pueden causar problemas con las baterías y quemaduras de baja temperatura. Por favor, úsalo para un calentamiento rápido.
*El gráfico de temperatura muestra los resultados de las mediciones en interiores. Por favor, refiérase a estos valores como referencia.
*Si la manga del acelerador tiene costillas no giratorias, hay que raspar la manga para que coincida con el diámetro interior del puño. Incluso si la manga del acelerador no tiene un retén, debes raspar la manga para que coincida con el diámetro interior del mango.
*La manga del acelerador no está disponible.
*Asegúrese de usar el adhesivo Hot Grip (vendido por separado).
Φ22.2mm handlebar 12V models only
Grip Length: 120mm End-through type (Bar end can be attached)
Grip inner diameter (right): Φ24.4mm (left): Φ21.2mm
Grip O.D.: Φ33.6mm
*Please be aware that running at LEVEL 3 & 4 may result in battery failure or low temperature burns.Use for rapid heating.
*The temperature graphs are measured indoors.Please refer to these values for reference.
*If the throttle sleeve has any ribs, you will need to remove them.Even if the sleeve does not have a non-turning stopper, please cut down the sleeve according to the inner diameter of the grip.
*Not compatible with FLAT throttle sleeve.
*Make sure to use the special adhesive for Hot Grip (sold separately).
*High temperature.Never touch with bare hands.
*Doing so may result in low temperature burns and battery overload.
*There may be changes in product specifications due to the manufacturer's reasons.