montaje de la bola

[How is it used?
When considered as a single product, the longest is less than 5 years, or about 60,000 km.
Drive in Touring or Circuit.
The mirror holder for NISSIN's brake master (YZF-R25, CBR-250RR), CF-POSH Universal mirror holder, YAMAHA 5YU-26393-00, and many others.
The Ram Mount is used in combination with a short arm and a smartphone holder to hold heavy objects such as an iPhone 12 mini, Xperia 5, Galaxy S21, and Driveman BS- 8.

Was the one you received as per Image?
In the Instruction Manual, there is a piece of Pole Rubber stuck to the base of the ball, and for better or worse, it's just like the Image.

Was the installation difficult?
Since the entire circumference is round and there is no flat surface to apply a tool to, the bolts can be installed with a right hand turn, but it may require some ingenuity to tighten them.
It may be possible to use a Clamp or a Monkey Wrench to hold it in place, but I'm using a Dustcloth wrapped in leather gloves to hold it in place, and then screwing it into the screw lock with all the screws dipped in it.

How was your experience with it?
There were no problems such as the ball falling out of the Bolt, the aluminum body cracking, loosening, or the Arm coming off, and the mounted devices are working fine.

[Included Parts:were they on?
Although it says that the screw lock is required, I'm pretty sure it isn't, so you'll need to prepare for it.

[Was there anything that disappointed you?
Nothing special. If you go to the store, you can see it, but it looks like Ram Mount, for better or worse.


It's an M10 1.25 Normal Thread Screw, which is the same bolt size as most Mirror holders, so it should be easy to install.
However, because the screw part itself is not that long, and because it is aluminum, and because it is difficult to remove, it is not good for tightening together.
On the other hand, since it has to be installed using the screw lock without any tools, it is better to think that it is difficult to remove it. I tried to remove it by squeezing it under the same conditions as when I installed it, but it didn't seem to budge.

It competes with Quad Rock and SYGN HOUSE, and as a product, it has lost quite a bit in terms of its beautiful appearance, but I have yet to encounter any irritating or critical aspects in practical use.

First of all, it looks dirty for some reason. It was a messy finish.
It doesn't affect the use of things, but it does bother me.

The GSX-R125 that I installed has a mirror hall because the Handlebar is a common part with the GSX-S125. I installed it there.
Installation is just finger screwing, so I'm worried about losing it.
I would like to be able to tighten it with a tool.

It is convenient because the Mount base for RAM can be added to the Screw hole of M10.
You can't hang a tool on it so you need to grab it with ArmParts and tighten it.

I've never had it come loose while driving by just grabbing it with the Arm and turning it.
It's not Firmly tightened, so I hope they improve it.

If you use Mirror's hole or an empty Screw hole, it's not usually noticeable.
The Spanner groove is also left uncut and round, so you may need to be a little creative to install it.
And the build is rough.

I took advantage of the hole in the vehicle's body and installed it for the GoProMount.

You can install it in any position to enjoy powerful images easily!