Rear master (Gail) It is easy to use because it is used for
Purchased this time with the addition of Sam Brake master.
Air removal is much easier.
- Instock
22.47 EUR (3,881 JPY)
Webike Point: +39 pt
(0.22 EUR)
información de entrega
In Stock, Ships within 24 hours.
Estimated arrival date around
Descripción del producto a continuación se traduce automáticamente por Google.
Product detail
Hecho por GOODRIDGE
material : acero inoxidable
tono de perno : P1.00 individual (para brembo)
**Por favor, compruebe el tono del perno antes de elegir.
*Otros colores están incluidos en la imagen..
Haga clic aquí para ver la tapa de goma para los tornillos de banjo sin aire
Haga clic aquí para ver otros tipos..
El fluido puede ser removido de la porción de sangrado del perno de banjo para una rápida remoción de aire.. Puedes elegir entre una amplia gama de colores.. (Algunos colores no están disponibles dependiendo del tono del perno.. )
Precaución
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Opiniones de los usuarios
Reviews with image
Jul 10, 2022
Used for Rear Sam Brake master
Helpful?
Mar 7, 2011
It is used for exchanging clutch masters by a master side.
Since the place where the master itself clings the hose of a banjo part was coming to the upper part, it was easy to do putting in oil by an air-free type.
Helpful?
Dec 13, 2021
Required for NisshinHorizontal TypeMASTER
I was having a hard time bleeding the air out of the NisshinHorizontal TypeMaster Cylinder. When I used this Banjo bolt, air bleeding was finished without difficulty. The hose for air bleeding sticks firmly and does not come off easily.
View DetailHelpful?
Dec 30, 2020
Required for the old Crab caliper?
Installed on brembo old Crab caliper.
With the Caliper installed, the Bleeder Bolt is in a position where there is no way to turn it, so it's nice to have a product like this.
This allows you to replace the Fluid without removing the Caliper.
(You have to remove it to bleed air.)
The screw part is too long to fit on the OEM Banjo.
Two Washer on top and bottom (Total Quantity):(1 Set of 4pcs.) I used it.
Helpful?
Sep 26, 2020
Rear master - for venting air from the top
I installed it on the upper side of the NINJA400's rear master.
Rear brake piping can be long and complicated, especially on ABS-equipped models, which can make it difficult to bleed.
Therefore, I installed this Air Free Banjo Bolt in anticipation of improving air extraction around the Rear master.
It's easy to install:Remove brake fluid on the rear side, remove the rear master - upper Banjo bolt, then install this Air Free Banjo Bolt. (Crash washer is included in the kit.)
Then inject Brake fluid and remove air. I tried this Air-free Banjo here. The result is probably OK. it is uncertain whether it is the effect of this Air-freeBanjo, but Fluid injection and air removal could be completed in Smooth without air bite.
In the case of NINJA400, if you install the Air-free Banjo on the upper side of the rear master, it will interfere with the original plastic cover. Therefore, it is necessary to cut a part of the resin cover. I used a hot knife to cut the resin cover as shown in the photo.
Helpful?
New Custom Articles
