Banda silenciadora (Acero inoxidable)

I bought a silencer band from KITACO because I changed from Earls Gear's silencerφ100 to Universal Product's silencerφ80.:It looks very beautiful and sturdy with Stainless Steel, but I had trouble fixing it because the diameter of the silencer is 1cm lower than the original one. I would be happy if there was a type that could adjust the length of the mounting part as well as the type of φ, but I guess it would be difficult considering the cost. (Especially, it is difficult to extend the length by 1 to 2 cm because you cannot put a bracket between them.) The silencer was too large, and when I put in the rubber sheet, the phi; became a little too small to reach, and I put in the 6mm spacer and installed it. By the way, Material:Although Aluminum is availableMaterial:Titanium is expensive and unprofitable, isn't it? If possible, is it possible to get a one-off price at Netetc.?
It is very helpful to have a manufacturer like KITACO who provides various universal products and parts at a good price.
Please keep up the good work. I'm rooting for you.

Vino (SA10J) I used it to
The exhaust system of N company is installed The exhaust system of Silencer fixed by aging
The Rivet was loose and I used the Hand Riveter to re-hit it

I'm worried about it, so I bought a Silencer band to fix it to the body of the car
The Silencer band and bracket for the body are made by the T Company

Put it between the Silencer and the attached HexagonalBolt&Nut
It's only 13mm, but Nut is 13mm, so you need to be careful about the tool you use
This is where you want them to use the 14mm Nut that is commonly used for Motorcycles

Align the Bracket with the HexagonalBolt and tighten up the HexagonalBolt to avoid wobble
Firmly fixed

The construction of the bending part is very solid, and the Material:Stainless Steel, so it will rust
It's good to have no worries
I like it because it has excellent cost performance at a reasonable price

When installed in Silencer of YOSHIMURA, about 10? Spacer is required. I think that it is because the outer diameter becomes smaller with the thickness of the Elastic band, but it was unexpected. I caught a friendly Nut and managed to install it. Although it is a little narrow compared to YOSHIMURABand, the glow of Stainless Steel is about the same, so I think it is a good item to go from Cost performance.

Because there is no Silencer Band, I purchased this product, but it was a failure. I measured the number of pies
The Band part floated and it passed through it.
For the adjustment, we inserted a Rubber between Rubber and it went well.

If you use KIJIMA 's AluminumBand, it will be packed up in about a month
So I was in trouble and made this.
In Stainless Steel it was inexpensive that the deciding factor of purchase.
The thing is also the wall thickness (At least from Aluminum) It is robust..
It will not break.

Just remove the Rubber board and set it up with Aluminum silencer and galvanize and Silencer side
It became textured. If it is Stainless Steel it can be as it is,
If the other party is a heterogeneous Gold genus, it is better to use the attached Rubber board without fail.