- Lighter than expected, looks good, and now that the Blinker has been replaced.I feel like we should change it at this point.Lee mas
- Fender Eliminator and Quantity because I fell and broke my Stop-lamp.:I bought it because I thought it was a good deal in Set.I'm a little disappointed that it doesn't come with a Connector as others ...Lee mas
- I'd order DRC Motoled edge aluminum holder kit with smoke lens, the bracket is titanium color (not black color), but I like this color. I take about fifteen minutes to removethe original license plat...Lee mas
- I thought it would be a little easier to install, but the instructions in the manual tell you how to remove the OEM Product internal reasonIt took a long timeI also went to Home Center to buy a Harnes...Lee mas
- I bought it because I thought it was a Fender Eliminator firstBecause the blinker bracket that came with it was a hole of M8, it was substituted with the Homsen bracket I did The shape is satisfactoryLee mas
- Very nice and small it is easy to install I'm fully satisfied with the design
and it is clear during daytime especially at night all led bulbs are working good
I just put additional sealant to make ...Lee mas - We use this Manufacturer as if it were such a thing.Every time I change the vehicle, I will put in this DRC's Fender Eliminator Kit, but every time Tail light has a problem. Last time four LEDs un...Lee mas
- Fender Eliminator Kit is troubled because there are many kinds, but this is Recommendation. Off Because the fall is an attachment, it is safe to make it easy to correct even if it is distorted.Photo B...Lee mas
- Purchase to make Rear clean. Since OEMBlinker is not attached, replace with LED Blinker. Although attaching is easy, it is necessary to separately prepare the Coupler separately, although it is exclus...Lee mas
- Before purchasing this product, I bought a similar item, but the similar item could not be installed with inferior goods.Since it was after bought bad goods, it was uneasy whether it could be installe...Lee mas
- Because thick Aluminum material is subjected to Shot blast treatment and finished with Gray's Anodized, feeling is high in addition to your own thoughts. LED Lamp also has enough illuminance, you ...Lee mas
- I do not like the Rear around the OEM Product's draft, so I chose this product for Fender Eliminator.As impressions after installation, I like Refreshing and I like it very much.Tail lamp is also ...Lee mas
- It attached to the KLX250 [ present ]. When it had ridden for a while, some Lamps were lost in the point.Although I got the Manufacturer to exchange by initial failure, since it is LED too, is it weak...Lee mas
- the angle of the Number was right just at oneself liking, the form of the Tail lamp backed up the Style of KLX, and became smart, and it differs from the time of of a NORMAL completely -- it is like ...Lee mas
- They were goods in which do not break down the form of the Fender of a NORMAL, but-izing of it can be carried out [ Fender less ], and serious satisfaction goes.
In my case, since the Tail lamp and ...Lee mas - Since the pure mudguard was damaged by the fall with a Touring, it Fender-less-ized with the LED Tail of DRC.
The thing for XR250 was attached to CRM250AR.
It became a racy atmosphere and satisfied...Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING