What made you decide to buy?
I have been using a certain Rear stand, but it is a little too large for Grom. This time, when I changed to the G-CraftSwing Arm This time, when I changed to G-CraftSwing Arm, the OP's Racing Stand I made a HookSpec. and a certain Rear stand that was a little too large for me. I purchased the TRIPNarrowRoller stand.
How was your experience with it?
I compared a certain Rear stand and J-TRIPNarrow. First of all, it is the Caster diameter of both stands that I compared. You can work smoothly when you hang a STAND. Actually, I tried to hang the STAND in the unstable place at home, but it is more stable than a certain Rear stand and can work smoothly. It was easy to work with. The next comparison is the pipe diameter of both stands. The Pipe diameter of a certain Rear stand is 32mm and it is mainly Small type to medium size. It is STAND for Motorcycle. The Pipe diameter of J-TRIPNarrow is 29mm. The vehicle of 50cc to 400cc Class seems to correspond mainly. The build quality is also good, and it is sturdy for a Small size. Moreover, the paint quality has finished beautifully in Made in Japan. The maintenance of my car GROM can be done at ease. The height adjustment of the bracket is fixed in a certain STAND, but the J-STAND is not. The height of the receiving bracket can be adjusted in 3 levels. I actually checked it on my car GROM (Tire and foil are OEMSize). After checking, the GROM was high enough on the first tier, although the second tier is slightly higher than the first. We recommend the stable first stage for OEM size Tire Foil! Then maybe the second step? And... The third level is quite a bit higher than the first one. If the height is too high, the body may be unstable when you apply STAND. Small TypeMotorcycle is not recommended. In case you're wondering, I put 2×4 wood on the picture of the confirmation work, just for reference! It is.
Was the installation difficult?
Caster bearing Bracket coated with Silicon grease and Screw Use a Hexagonal Wrench with screw lock agent to prevent the Installation to J-TRIPNarrowRoller stand Manual etc. is not attached, but the parts are only Caster and receiving Bracket. No. Don't worry! It's a simple process!
[Tell me the hang of using STAND]
I used the DAYTONAFront Brake Lock to make the front brake Locking the front brake in place before using STAND. If you support your Rear with your Left hand and lower the STAND, the STAND is easily released. You can also purchase the DAYTONAFront Brake Lock at Webike When you hang up the STAND, don't knock over your beloved car for a large amount of time. Like!
Do you have any wishes or suggestions for the Manufacturer?
I also bought a VPlate receiver at the same time, and as expected, it is made in JapanQuality. It was a great build. Quantity to suit your taste and receiving Bracket:It's a good idea to buy a set of these products as well. It's a sturdy product, so I think it's a very useful product.
[Do you have any products to compare it to?
J-TRIPNarrowRoller stand is the only one available. I decided to buy it with J-TRIP.
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING