Tipo de filtración de bloque de metal
El tamaño. : φ6.5 (tipo recto)
[Dimensiones.]
El diámetro interno de la parte de inserción : 3,9 mm de diámetro
El diámetro exterior de la parte de inserción : 6,5 mm de diámetro
Diámetro exterior máximo : φ30.7
longitud total... : 74.6mm
Diámetro de la manguera aplicable : 6,0 a 8,5 mm de diámetro
*125 cc o menos*El diámetro exterior máximo es el diámetro exterior de la parte de la articulación del cuerpo.
*La longitud total incluye la parte de inserción.
*El diámetro de la manguera es sólo para referencia.
[Nota]
* Cuando el filtro no desmontado se obstruye con suciedad, es hora de cambiarlo. Si no se cambia el filtro, el camino del flujo se bloqueará por el polvo y la gasolina no será suficiente. Para evitar tal situación, debe considerar la dirección de la instalación.
* No se puede usar para carburadores de gran diámetro como el FCR. Si lo usas, no podrás suministrar suficiente cantidad de gasolina al carburador.
* Debido a que está hecho de resina, no es resistente al calor. Por favor, instálelo en un lugar donde no le afecte el calor, como un motor. Puede ser deformado por el calor.
* La ruta de flujo de la gasolina es específica para cada producto. Por favor, compruébelo antes de la instalación.
* Inserte la manguera y asegúrela con la banda. Si no se hace así, puede producirse una fuga de gasolina, lo que puede dar lugar a graves accidentes, como un incendio.
Metal Block Filtration Type
Size: Φ6.5 (Straight type)
[Specification]
Inner diameter of insertion part: Φ3.9
Outer diameter of insertion part: φ6.5
Maximum outer diameter: Φ30.7
Full Length: 74.6mm
Applicable hose inner diameter: Φ6.0 to 8.5
*125cc or less *Maximum outer diameter is the outer diameter of the mating part of the body.
*Overall length is the total length including the insertion part.
*Compatible hose diameters are for reference only.
[Caution.]
*It is time to replace the non-dissolving filter when it is clogged with dirt.If left unchanged, the flow path will be blocked by debris and the gasoline flow will be insufficient, so it is necessary to check it frequently.In addition, please consider the direction of installation to avoid such a situation.
*Cannot be used with large diameter carburetors such as FCR.If used, a satisfactory amount of gasoline will not be supplied to the carburetor.
*Resin products are not resistant to heat.Install the unit in a location where it will not be affected by heat from the engine.It may be deformed by heat.
*The gasoline flow path is fixed for each product.Please check before installation.
*Insert the hose and secure it with the band.If it is not secure, gasoline may leak and cause a fire or other serious accident.