El diámetro del agujero : 54mm
golpe : 63.1 mm (normal)
relación de compresión : 11.2 : 1
*Al instalar el kit de perforación de la etapa S, se requiere instalar al mismo tiempo el FI-CON TIPO-e (controlador de inyección).
*Dado que el desplazamiento del ciclomotor es superior a 125 cc, no se permite conducir en la vía pública en caso de matriculación de ciclomotores de segunda clase. Es sólo para uso de la competencia.
*En cuanto a la instalación de un kit de perforación
El cigüeñal está sometido a una mayor torsión y flexión debido al aumento significativo de la potencia del motor y del par motor con el kit SP Mukawa Bore Up.
SP Mukawa recomienda instalar el adaptador de soporte del cigüeñal al mismo tiempo para reducir la carga sobre el cigüeñal.
Los adaptadores de soporte del cigüeñal están diseñados para añadir un soporte de rodamiento de bolas al extremo del volante del cigüeñal para reducir las torceduras y las deformaciones y aumentar la durabilidad del cigüeñal.
Adaptador de soporte del cigüeñal para GROM (JC92) (Nº de pieza 01-10-0149)
*Al instalar el kit de perforación S-stage, los árboles de levas deportivos y el FI-CON TIPE-e, es necesario instalar al mismo tiempo los "Inyectores de alta capacidad (G1) (Nº de pieza 00-00-0487)".
*Tenga en cuenta que las especificaciones del producto pueden estar sujetas a cambios debido a la conveniencia del fabricante. Por favor, entiéndelo.
*Dependiendo del lote, es posible que reciba el producto con el antiguo precio y la etiqueta con el antiguo código JAN antes del cambio de precio. Tenga en cuenta esto.
Bore Diameter: 54mm
Stroke: 63.1mm (stock)
Compression ratio: 11.2: 1
*When S-stage Big Bore Kit is installed, FI-CON TYPE-e (Injection Controller) must be installed at the same time.
For competition use only.
*Related to the installation of a big bore kit
The crankshaft is subjected to increased torsion and deflection due to the significant increase in engine power and torque caused by the SP Takegawa big bore kit.
SP TAKEGAWA recommends to install crankshaft support adapter at the same time to reduce the load on the crankshaft.
The Crankshaft Support Adaptor adds ball bearing support to the end of the flywheel side of the crankshaft to reduce twisting and deflection and to increase the durability of the crankshaft.
Crankshaft Support Adapter for GROM (JC92) (Part No: 01-10-0149)
*When installing the S-stage Big Bore Kit, Sports Camshaft, or FI-CON TIPE-e, be sure to use the "High Capacity Injectors (G1) (Part No.: 00-00-00-0487) " must be installed at the same time.
*There may be changes in product specifications due to the manufacturer's reasons.
*Depending on the lot, the product may be delivered with the old price and label with the old JAN code before the price change.