El período de garantía del fabricante : Ninguno (sólo fallo inicial)
Tiempo de instalación : 0.2h
[Material]
Cuerpo y sección de sujeción : Resina + Goma
Brazo : acero inoxidable
[Dimensiones (aprox.)].
Diámetro de la pinza aplicable : Φ22/Φ25.4/Φ31.8
Tamaño smartphone acoplable : 130 mm-175 mm de largo, 60-90 mm de ancho, hasta 15 mm de grosor
Peso (aprox.) : 240 g (incluidos cuerpo, STAY y pinza)
Ejemplos de modelos de instalación confirmados : iPhone 8 / X / XS / XR / 11 / 12 / 13 / SE Samsung Galaxy S8 / S9 / S10 etc
Descripción del producto : Consulte el manual de instrucciones.
*Antes de fijar este producto a la carrocería del vehículo, asegúrese de que el smartphone que va a utilizar está fijado al soporte y bien sujeto.
*Si hay un hueco en el lado izquierdo o derecho, afloje los tornillos de la parte trasera y ajuste. Apriete siempre los tornillos después del ajuste.
*Tenga en cuenta que la garantía del fabricante no se aplica a las diferencias de grado debidas a diferencias de materiales, métodos de fabricación o productos individuales.
*El color del producto puede variar dependiendo de las condiciones fotográficas, el monitor, el tamaño del lote y los lados izquierdo y derecho del producto.
*En el manual de instrucciones se describen otras precauciones, así que no deje de consultarlas.
*Tenga en cuenta que las especificaciones del producto pueden estar sujetas a cambios debido a la conveniencia del fabricante. Por favor, entiéndelo.
None (only initial defect)
Installation time:0.2h
[Material]
Main body and holding section: Resin + Rubber
Arm: Stainless steel
[Dimensions (approx)]
Compatible clamp diameter: Φ22/Φ25.4/Φ31.8
Attachable Smartphone Size: Height 130mm -175mm, width 60-90mm, thickness 15mm or less
Weight (approx): 240g (including main unit, STAY, and clamp)
Example of confirmed installation model: iPhone 8 / X / XS / XR / 11 / 12 / 13 / SE Samsung Galaxy S8 / S9 / S10 etc
Product Description: Refer to the instruction manual
*Before attaching this product to the bike body, please make sure that the smartphone to be used is attached to the holder and secured in place.
*If there is a gap on either side, loosen the screws on the back side to adjust.After adjustment, be sure to tighten the screws.
*Individual product differences may occur due to materials and manufacturing methods.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product, but returns or exchanges is not accepted.
*Please be sure to check the instruction manual for other precautions.
*There may be changes in product specifications due to the manufacturer's reasons.