Modelo sencillo que se calienta al conectarlo al enchufe USB (Tipo-A) previsto en el vehículo.
[calentador de agarre de clip]
Fijación y retirada con un solo toque
La instalación es sólo una cuestión de "encajar y conectar la alimentación"..
Como es fácil de quitar, también es posible "quitarlo según la temporada, utilizarlo en varias motos"..
Corresponde a un agarre normal del mango (para el mango de 22 mm: Φ30 mm-Φ34 mm de diámetro exterior), pero si le preocupa la holgura, utilice las bridas adjuntas como ayuda..
No es compatible con las empuñaduras americanas y otras empuñaduras gruesas (para mangos de pulgadas). *Patentado*.
Uso eficiente de la energía.
Adoptando un material de calentamiento con alta eficiencia de conversión de calor y concentrando la superficie de calentamiento, lo hemos diseñado para aprovechar al máximo la potencia de 10W..
En comparación con el tipo de sustitución de la empuñadura, se puede reducir la pérdida de calor en el tubo de la empuñadura y la diferencia de temperatura debida a la diferencia de grosor entre el lado izquierdo y el derecho..
10W es el mismo nivel de consumo de energía que los intermitentes, y no hay que preocuparse por quedarse sin batería, algo habitual en los productos de calefacción..
Puede ser un poco insuficiente para los clientes que requieren la misma capacidad de calor que el tipo de reemplazo de agarre, pero es un producto con un excelente equilibrio de comodidad y funcionalidad..
Simple model that heats up when connected to a USB plug (Type-A) equipped in the bike.
[clip grip heater]
■One-touch attachment and removal
Installation is as simple as "snap it in and connect the power".
Since it is easy to remove, it is possible to "remove it according to the season, and to use it in several bikes".
Regular handle grips (for 22mm handles: However, if you are concerned about looseness, please use the bundling band provided.
Not compatible with cruisers and other thick grips (for inch handles).*Patented*
■Efficient use of power.
By adopting a heater material with high heat conversion efficiency and concentrating the heating surface, it was designed to make the most of the power of 10W.
Compared with the grip replacement type, the heat loss to the handle pipe and the temperature difference due to the difference in thickness between the left and right side can be reduced.
10W is the same level of power consumption as blinkers, and there is no need to worry about running out of battery, which is a common problem with heater products.
Although it may be a little insufficient for customers who require the same heat capacity as the grip replacement type, it is a product with an excellent balance of convenience and functionality.