¡Un grosor de 1 mm, alta velocidad de corte y refuerzo de la red para evitar la rotura!
Muelas de corte de metal para amoladoras de disco de 100 mm.
Se utiliza principalmente para cortar metal.
[Características, Grosor: 1 mm]
Espesor delgado de 1 mm y alta velocidad de corte, especialmente adecuado para cortar materiales delgados..
Es delgada, pero el refuerzo de la red hace que sea difícil de romper..
[desconectado]
De hecho, no lo cortamos, sino que lo cortamos en una sección transversal delgada..
Es más fácil avanzar recto con menos desgaste si se aplica como se ha descrito anteriormente..
[Velocidad del molino de disco]
Cuando se usa a baja velocidad (bajas RPM), la fuerza centrífuga se hace pequeña, por lo que el contacto entre el disco de molienda y la pieza de trabajo se hace suave..
Esto facilita que la forma de la tela abrasiva encaje con la pieza de trabajo, especialmente en el caso de "suave" y "aire" donde la influencia de la fijación del sustrato es pequeña, y facilita la realización del rectificado y el corte de acuerdo con la forma de la superficie curvada..
También reduce el desgaste, los daños, las mordeduras y los enganches causados por las telas abrasivas volantes..
*Es fácil de operar de manera uniforme durante el acabado, lo que conduce a menos arañazos..
Por otro lado, el corte de alta resistencia resulta en una velocidad de corte más lenta debido a la disminución de la cantidad de trabajo debido a la disminución del número de revoluciones..
Para "Flat" y especialmente "Cut", recomendamos el uso de un tipo de rotación general de alta velocidad..
[Molino de baja velocidad]
*Un molino de disco de baja velocidad y alto par o un controlador de velocidad con función de cambio de marchas es la elección más común..
[Compatibilidad con bajas y altas velocidades]
Baja velocidad <ーー>alta velocidad
Suave/aire/plano/corte
40/120/320
1mm thin, high cutting speed and net reinforcement to prevent breakage!
Metal grinding wheels for 100mm disc grinders.
Mainly used for cutting metal.
[Features, Thickness 1mm]
It is especially suitable for cutting thin materials.
It is thin, but the net reinforcement makes it difficult to break.
[About the disconnect]
In fact, not "cutting" but "scrapng" in a thin section.
When using it, rather than pressing it strongly, use it in a way that "advances while applying it" with the image above to reduce wear and tear and to proceed straight.
[About the speed of the disc grinder]
When used at low speed (low rotation speed), the centrifugal force is reduced and the contact between the grinding disc and the workpiece becomes softer.
This makes the shape of the abrasive cloth more familiar to the workpiece, especially in the "soft" and "air" types where the fixing influence of the base is small, and makes it easier to perform abrasive cutting along the shape of curved surfaces.
In addition, the wear and tear, damage, biting and snagging caused by scattering of abrasive cloth can be reduced.
*It is also easy to operate evenly when finishing, leading to a reduction in scratches.
On the other hand, in heavy-duty cutting, the cutting speed becomes slower due to weaker contact and lower workload caused by reduced rotation speed.
For "Flat" and especially "Cut", recommending the use of a general high-speed rotation type.
[slow grinder]
*It is common to use a disc grinder with variable speed function, low speed and high torque type and speed controller.
[compatibility with low and high speeds]
Low speed <--------> High speed
Soft / Air / Flat / Cut
40 / 120 / 320