Tipo de montaje de cabeza y fondo
Montado en la parte inferior de la cabeza del cilindro con tirantes.
*Este kit es compatible con SHIFT UP y con las culatas de los cilindros. No hemos podido confirmar la compatibilidad con las culatas de otros fabricantes o con los diferentes números de bastidor. Tenga en cuenta que no hemos podido confirmar la compatibilidad con las cabezas de cilindro o los números de bastidor de otros fabricantes.
*En el caso de este kit de refrigeración de aceite, el tapón del lado del escape es sólo de serie. Si desea instalar otro tapón de rosca, por favor, cambie de nuevo al tapón de rosca de serie antes de instalar este kit de refrigeración de aceite.
*La estancia de este refrigerador de aceite es un tipo que debe ser apretado junto con la tapa de la cabeza, por lo que la tapa de la cabeza de palanquilla (401001-03/11/20) por SHIFT UP o la tapa de la cabeza de palanquilla puede ser instalada al mismo tiempo. Las otras cubiertas de la cabeza no son compatibles con SHIFT UP.
*Dependiendo del tamaño del neumático y la altura de la marcha, existe la posibilidad de que el neumático y el refrigerador de aceite interfieran entre sí en la parte inferior. Si parece interferir con el enfriador de aceite, debe ajustar la distancia entre el enfriador de aceite y el neumático sobresaliendo la horquilla o cambiando a un neumático de menor diámetro.
*Como el refrigerador de aceite incluye las partes no reutilizables, hay que prepararlos por separado.
Genuine Honda Part No. 90443-035-000 Item No.: Washer A Sealing 6mm
Head Bottom Mounting Type
Attached to the bottom of the cylinder head with a bracket
*This kit is compatible with SHIFT UP and stock cylinder head.This product's compatibility with the third company's cylinder head and other frame numbers than compatible models is not tested. Do not try to mount this to them.
*Only stock tappet cap on the exhaust side can be used when installing this oil cooler.If you are using a non-stock tappet cap, please replace it with a stock tappet cap before installing this oil cooler kit.
*Because the bracket of this oil cooler is tightened with the head cover, it can be installed with SHIFT UP's billet head cover (401001-03/11/20) or stock head cover at the same time.Please note that SHIFT UP is not able to confirm the compatibility of other head covers.
*Tires and oil cooler may interfere with each other at full bottom depending on tire size and ride height.Always check for interference before driving and if interference is likely or occurs, adjust the distance between the tire and oil cooler by protruding the fork or changing to a tire with a smaller outer diameter.
*Since the installation part of the oil cooler bracket contains non-reusable parts, it is necessary to prepare them separately.
Non-reusable parts HONDA stock part number:90443-035-000 Product Name:Washer-A Sealing 6mm