Material de la tubería EX : titanio (Ti)
El diámetro del tubo EX : 42.7φ
El diámetro exterior del tubo de cola : 60.5φ
*Los deflectores finales ya están instalados en el silenciador en el momento del envío.
*Los silenciadores cónicos de titanio V-1/V-2/V-3 tienen soportes, por lo que no se incluye una banda de silenciador.
El amortiguador de sonido del silenciador NITRORACING no debe ser removido. Se recomienda comprobar y revisar la lana del silenciador interno a intervalos regulares.
El silenciador de la granada de titanio se montará con una banda silenciadora de 90 mm de diámetro.
Necesitas cambiar a un solo tipo de paso atrás. Cuando cambias del paso estándar al paso tándem, hay que cortar el marco del paso tándem.
En los vehículos ya equipados con el NITRO RACING Tandem Step KIT Tipo 1, es posible que la parte superior del silenciador pueda interferir con el Tandem Step KIT dependiendo de la posición de la placa de montaje. Le recomendamos que utilice el KIT de paso en tándem tipo 2.
Algunos tipos de intermitentes pueden interferir con el silenciador. En este caso, tienes que cambiar las anteojeras.
Es necesario cambiar la tapa del filtro de aceite y los pernos de drenaje al tipo plano. El kit de cubierta plana y drenaje está incluido en los accesorios de este producto, así que por favor cámbielo cuando instale el silenciador.
Exhaust pipe material: Titanium
Exhaust pipe diameter: Φ42.7
Tail pipe outer diameter: Φ60.5
*The end baffle is pre-installed on the silencer at the time of shipment.
*Conical titanium silencers V-1 / V-2 / V-3 do not come with a silencer band as a bracket is pre-installed.
Never remove the exhaust baffle from the NITRO RACING silencer.It is also recommended to check and overhaul the silencer's internal sound deadening wool on a regular basis.
The grenade titanium silencer will be mounted with a φ90 silencer band.
It is necessary to change to a single type rearset.In this case, it is necessary to cut off the frame of the pillion step when you replace the stock one with this product.
For bikes already equipped with the NITRO RACING Pillion Step Bracket KIT Type 1, the upper part of the silencer and the Pillion Step KIT may interfere with each other due to the welding position of the mounting plate.It is recommended to use Pillion Step Bracket KIT Type 2.
Depending on the type of blinker, it may interfere with the silencer.In this case, you will need to replace the blinkers.
The oil filter cover and drain bolts must be changed to a flat type.The Flat Cover & Drain KIT is included as an component of this product and should be replaced when the exhaust is installed.