La parte trasera también está moldeada por el proceso de prensado en frío para asegurar un ajuste perfecto..
Es un tipo que se ajusta junto con la cubierta del maletín (cubierta del generador)..
Si la caja está recubierta, puede que no sea posible instalarla debido al grosor del recubrimiento..
Si usa sólo el Kepler de fibra de carbono o el collar de fibra de carbono, puede aflojar el tornillo comprimiendo la fibra mientras conduce.. Va a estar muy apretado..
Además, tenga en cuenta que la cubierta secundaria en sí misma tiene un grosor de 1,5 a 2,0 mm, por lo que los tornillos deben ser insertados en el agujero justo debajo del lado de la cubierta secundaria.. Como los agujeros se hacen a mano, puede ser difícil insertar los tornillos debido a errores en el producto.. Si haces esto, por favor usa una lima de palo para raspar un poco..
The back side is also shaped by the cold-pressing method and adheres firmly.
It is a type that tightens together with the stock case cover (generator cover).
If the case is painted, it may not be able to be installed due to the thickness of the paint film.
I decided to insert an aluminum collar as a countermeasure for the loosening of the screw because there is a case that the fiber is compressed while riding even if it is tightened to the specified torque with the carbon coupler or carbon alone.Now, torque is applied tightly.
Also, please note that the secondary cover itself has a thickness of 1.5 to 2.0mm, so the screws must be inserted through the holes just at the side of the secondary cover.The hole itself is drilled by hand, so it may be difficult to insert the screw due to product errors.In this case, please use a stick file to remove a little.