- This Glass Wool is used for the exhaust pipes of the Exhaust System. It is relatively inexpensive and the material is easy to roll, so it is easy to work with.Lee mas
- When I was looking for Heat Insulating Material to make Heat Guard.This product has been found (・∀・)It is less expensive than similar Insulation Glass Wool.The heat resistance temperature is re...Lee mas
- I bought it to wrap around my 2-stroke Chamber.Wire and wire twister are necessary. It is necessary to make the appearance beautiful. It becomes a heat-shielding, but I am not sure whether the perform...Lee mas
- My own motorcycle has a Center out, so my thighs and butt get hot, and it's an afterthought To protect electronic devices and pipes, etc. from heat, the inside of the heat shield and the exterior surf...Lee mas
- I use it to protect my Under Cowl After about 10,000km of use, the silver foil-like part of the surface has come off, but Heat It seems to keep its performance as an Insulating Material, and for now, ...Lee mas
- I installed it on the ZrX1200R where the back of the Fuel Tank is not heat resistantThis is a countermeasure against gasoline seepage from the tank capPreviously, the Cork Board and Material:I was wea...Lee mas
- Even when compared with other company's product called ThermoGuard, appearance and quality did not change. Because making is also quite the same, the performance is probably the same. (Although DA...Lee mas
- I bought it because the Under cowl center panel of my Motorcycle ZX - 12R melted with the heat of Exhaust pipe (sweat)When ordering a new OEMPanel with a Motorcycle shop, the price is 10,000 yen! What...Lee mas
- Used for external Cowl of NSR 250. There is a part that comes in contact with the Exhaust Chamber, so I stuck it to the back as Cowl melted. How to use Cut to the appropriate Large dress with Scissors...Lee mas
- [Webike Monitor] Since the sheet was hot, it stuck on the back side.
if it runs for 2 hours although the sheet becomes difficult to get hot -- -- it is ineffective.
I thought whether it was Massey w...Lee mas - When I have you make it a little larger slightly, it is that it is kind.
It was a Limit although we had expected it could use firmly by one sheet.
Lee mas - It is used for RGV-gamma 250. Since the cowl was exchanged for the external new product, I stuck to the position which a chamber touches. Although such heat-resistant product is simple, it is not good...Lee mas
- [Webike Monitor] It purchased in the heat-resistant measure against the Undercowl.
> -- the part which takes heat-resistant measures in mini neighborhood which is inserted into a favorite size, and o...Lee mas - This product was purchased as a measure against heat of the neighborhood and a muffler to change the right side cowl of XR into the product made from FRP. Work is only the easy work cut and stuck on s...Lee mas
- It purchased in order to stick on the back side of the side cover of the off-road motorcycle under restore. A vehicle type is suzuki TS125R. Since there was still manufacturer stock of a side cover, t...Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING