- Encaja:
- HONDA NSR250R 94-
- HONDA
- HONDA
- HONDA
- HONDA
We are using it for nc30. It seems to be a good product.Lee mas - This stainless steel is used for fixing the holders of the rear sets, which is rust-resistant.It was a little cheaper to have a few bottles in the box.Lee mas
- This rust-resistant stainless steel is used for fixing the holders of the Rear Sets.Quantity:1 Set of 2pcs. and the price was reasonable.Lee mas
- 08 KawasakiZrX400 and KOSO (KN Planning) Used in combination with Sequential Blinker inWorked fine.However, the product description does not recommend the use of other manufacturer's blinkers, so the ...Lee mas
- This product can be easily dressed up by replacing rusted screws. It was a good price because there were quite a few in the box!Lee mas
- I used this product as a replacement for Axle Shaft's Split Pin, and the Stainless Steel gives it a more luxurious feel and makes for a nice dress-up!Lee mas
- The Rust is not coming off.Lee mas
- This product can replace and dress-up the existing Bolt, and it is Rust resistant and highly polished, but it would be nice if it were cheaper!Lee mas
- I think it can be used for many things if the Size is right.Lee mas
- You should do Wiring to eliminate anxiety.Lee mas
- I've been using it for a little while now, and it's a great product.Lee mas
- The Axle Nut on my car uses a Split Pin.It's a pain to change the Split Pin every time I need to do maintenance on my tires, so I bought this Beta Pin to replace it.It's easy to remove and install, an...Lee mas
- The texture wasn't quite as good as I thought it would be, I wish the finish was better.Lee mas
- For zx25r, the Size is a little bit Large.It looks like Racer and Parenthesis is good.Lee mas
- I always use Split Pin, so if I can do the Smallest, I think Cost is the way to go.Lee mas
- Normally it is a Split Pin, but it is difficult to remove and there is a limit to the number of times you can re-youth it. This product fits snugly and is easy to remove.Lee mas
- The purpose of this product is to prevent the screw from loosening and coming off. I had a chance to see it at the race scene, and I wanted to install it on my car. The vehicle is ZX-25R, and it fits ...Lee mas
- When I changed my fuel tank to aluminum before, I bought this kind of insulated seat. I bought it for Repair because it was worn out. I bought this one because the Manufacturer's one I bought before w...Lee mas
- It has already been changed to KIJIMA's LED Blinker, and Blinker positioning was done as an additional function.I'm very happy with this product.Lee mas
- This product is a little too large for the front Axle Nut (Crown Nut) of FZr1000 3GM, but I installed it as an attachment.Moreover, because it becomes a little small feeling to the Axle Nut (CrownNut)...Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING