- Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
Well, it's like this ….It's just right for Refresh for now!Lee mas - Encaja:
- SUZUKI DL1000 V-STROM
- HONDA CB500F
- HONDA CB125T
- HONDA CB1000 SF (Big One)
- HONDA CB-1
- ...y más.
I want to cancel an order, but I don't know how.I don't know where to inquire, so I am writing here, even though it is out of place.I want to Cancel the order before it is shipped, but I am having tro...Lee mas - Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
I have often used Tie Wrap, but I had to cut it off and use a new one every time, so I bought it. I am glad I bought it, even though it seems rather expensive.Lee mas - Encaja:
- SUZUKI RF400 R
- SUZUKI GSX750E
- SUZUKI GSX400 E
- SUZUKI GSX250 E
- SUZUKI GSX400 F
- ...y más.
I didn't think of any other manufacturer because my previous car was also equipped with Mats Stripe.The OEM and durability of the W series are good, and I hesitated to replace it, but I thought that I...Lee mas - Encaja:
- SUZUKI DL1000 V-STROM
- HONDA CB500F
- HONDA CB125T
- HONDA CB1000 SF (Big One)
- HONDA CB-1
- ...y más.
When the weather is nice, I can see it well.
It's hard to see when it rains or the weather is bad.
I'm using all weather gold now.Lee mas - Encaja:
- KAWASAKI Z750FX -I
- KAWASAKI Z1000 MkII
[Color] I used to use the Smoke one, but I made a small mistake and tightened it with Overtorque, so the screw part was cracked a little. This time, I bought the normal Red one because Timing didn't h...Lee mas - Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
Purchased with Washer.Only Gasket is difficult to prevent from deteriorating.It is a necessity when replacing parts.To be honest, it would be a big help if you could stock only Gaskets by Manufacturer...Lee mas - Encaja:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z1-R/Z1-RII
- KAWASAKI Z1000
- KAWASAKI Z1000 MkII
- KAWASAKI Z2 (750RS/Z750FOUR)
- ...y más.
When reverting from Separate handle to STD Handlebar, the OEM Headlight BracketPurchased to re-install.If the cost was a little cheaper, I could be satisfied, but without this, the Light Bracket is ha...Lee mas - Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
Before attaching the Meter Wire to the Meter, you must run the Clamp through the Wire or you will have to start over.I've done it.Lee mas - Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
OEM Parts are still available. The price is not so different. What is the quality of Rubber?Which one shall we choose?Lee mas - Encaja:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...y más.
This is a very common part, but you will have to remove the fork to install it, so it will be tricky if you can't adjust it after reassembly. You need to have the right equipment to install this part,...Lee mas - Encaja:
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR) Conformity and other information]Old
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1
- KAWASAKI Z1000 MkII
I bought this because my meter cover was corroding badly, and I chose the cheapest one made by Mad Max from Reproduct. I was worried because of the low price, but the packaging is very good and the qu...Lee mas - Encaja:
- SUZUKI DL1000 V-STROM
- HONDA CB500F
- HONDA CB125T
- HONDA CB1000 SF (Big One)
- HONDA CB-1
- ...y más.
I bought it for the spare of CB125T JC06. It was darker than NORMAL and the optical axis was not clear. Well, it is the feeling that it cannot be helped for the price. When I tried to install it again...Lee mas - Encaja:
- SUZUKI RF400 R
- SUZUKI GSX750E
- SUZUKI GSX400 E
- SUZUKI GSX250 E
- SUZUKI GSX400 F
- ...y más.
The OEM light valve of SEROW250 ran out of bulbs, so I installed it.I ran out after just under 60,000km, so I'm happy to replace it when it gets over 50,000km.Compared to the OEM, it's about three tim...Lee mas - Encaja:
- SUZUKI DL1000 V-STROM
- HONDA CB500F
- HONDA CB125T
- HONDA CB1000 SF (Big One)
- HONDA CB-1
- ...y más.
Used by Z125PROI bought it as a stopgap measure because the Light of OEM was outThere is no difference between OEM and Large so far in terms of usageI thought about the LED, but the Gold amount is als...Lee mas - Encaja:
- SUZUKI RF400 R
- SUZUKI GSX750E
- SUZUKI GSX400 E
- SUZUKI GSX250 E
- SUZUKI GSX400 F
- ...y más.
Brightness, light distribution, ease of installation depending on the high precision of the product, etc.. It isThere are no messy parts and the durability lasts until you forget when you replaced itC...Lee mas - Encaja:
- KAWASAKI Z750FX
- KAWASAKI Z2 (750RS/Z750FOUR) Conformity and other information]Old
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI Z1
- KAWASAKI Z1000 MkII
Since the meter cover was dented and corroded due to ageing, I had to use the lower I considered buying it to change the cover at least While there are various reproductions, I purchased the one made ...Lee mas - Encaja:
- HONDA
- HONDA Forza (MF08) 04-
- HONDA Forza Z 04-
- HONDA
- HONDA
- ...y más.
I specified the make and model of car, but when I installed it, the claws didn't fit! In the end, I broke the claw in one place and shaved it off I looked at the compatibility list of the product I re...Lee mas - Encaja:
- HONDA
- HONDA
- HONDA
- HONDA CB125 TF
- HONDA
- ...y más.
Is it a little brighter than Halogen? AboutAlso, the heat sink needs to be shaved off a little bit to be able to install it on the WRI didn't expect it to be good or bad, as I just bought it for a tes...Lee mas - Encaja:
- KAWASAKI Z750FX -I
- KAWASAKI
Z1000 mkII changes the look and blends in with black paint work Top product fits perfectly would recomend this product to anyone Lee mas
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING